Welcome to the Connacher Oil and Gas Hub on AGORACOM

Connacher is a growing exploration, development and production company with a focus on producing bitumen and expanding its in-situ oil sands projects located near Fort McMurray, Alberta

Free
Message: Re: Results
3
Aug 12, 2010 11:23AM
2
Aug 12, 2010 11:57AM

Aug 12, 2010 12:12PM
4
Aug 12, 2010 12:14PM

Aug 12, 2010 01:12PM

Aug 12, 2010 01:30PM
3
Aug 12, 2010 05:28PM
1
Aug 12, 2010 05:33PM
1
Aug 12, 2010 06:35PM
2
Aug 12, 2010 07:05PM
2
Aug 13, 2010 10:54AM

For example, has anyone discussed how these power outages are affecting the goal of maximizing production? As you remember, the curtailment of production in March 2009 seemed to affect production levels. Before the shutdown, it appeared that design production was close to being achieved. Since the shutdown, Algar has not been able to break the 8,500 barrel level. What are the power outages doing to the pumps? Are they still able to inject steam during the outages? Are they experiencing brownouts are constant low voltage conditions? This can have a seriously damaging affect on their motors.

Good post oilman.That's what I like to know as well.If that's the case then it's out of their control a little bit.But how much damage do this outages bring to the output.If they do maintnance work they probably had to shut down some wells too.So a answer from guys with better knowledge about that should be welcome.

It looks we will not have the luck on our side on our sp1.27 just now and that means our support line in not valid anymore or a rebound till the end must be seen.I wouldn't be surprised if they push the sp towards around 1.20 wich was lowest point in May.

CC

Aug 13, 2010 12:55PM
3
Aug 13, 2010 02:23PM

Aug 13, 2010 02:47PM

Aug 13, 2010 02:58PM

Aug 13, 2010 03:32PM

Aug 14, 2010 11:55PM
1
Aug 15, 2010 07:56PM

Aug 15, 2010 09:55PM

Aug 16, 2010 09:56AM

Aug 16, 2010 10:42AM

Aug 16, 2010 11:37AM
1
Aug 16, 2010 01:46PM
1
Aug 16, 2010 02:12PM
1
Aug 16, 2010 03:18PM
1
Aug 16, 2010 03:36PM
Share
New Message
Please login to post a reply