Aiming to become the global leader in chip-scale photonic solutions by deploying Optical Interposer technology to enable the seamless integration of electronics and photonics for a broad range of vertical market applications

Free
Message: Board policy
24
Aug 09, 2017 10:02AM
11
Aug 09, 2017 10:29AM
36
Aug 09, 2017 10:34AM
16
Aug 09, 2017 11:12AM
3
Aug 09, 2017 11:24AM
8
Aug 09, 2017 06:15PM

Brundallreturn: Is that official agoracom policy on these forums? I think It would be a good idea Rainer if you could clarify to posters as to what crosses the line in your mind as a respected hub leader.

I have explained that some time ago, but I am too lazy to look up that post.

In short, facts are most welcome, followed by explanations and fact-based speculations and opinions – no matter whether positive or negative. This is what brings quality and insight to everyone here.

What we don't need are any groundless speculations, opinions, and – worst of all – airing of emotions. They are only misleading people and are, at best, a nuisance and a waste of time to those who won't let themselves be misled.

Repetitions multiply the nuisance. And yes, we already knew that the share price is disappointing, thank you!

Having said that, there will be always some noise with the signal. That's normal and okay. However, everyone should try to keep the signal-to-noise ratio of his or her posts significantly higher than 1, i.e. there should be significantly more signal than noise.

People bringing more noise than signal to the board only act as a disturbance factor. We don't need that. Nobody is required to post. Please think for a moment whether your post is signal or noise. If you are unsure, it's likely noise. You might better keep your post for yourself – or try the off-topic forum if you can't.

11
Aug 10, 2017 02:31AM
6
Aug 10, 2017 07:04AM
3
Aug 10, 2017 07:18AM
14
Aug 10, 2017 08:18AM
3
Aug 10, 2017 09:49AM
27
Aug 10, 2017 09:52AM
13
Aug 10, 2017 10:29AM
5
Aug 10, 2017 10:31AM
3
Aug 10, 2017 10:42AM
6
Aug 10, 2017 11:01AM
1
Aug 10, 2017 11:40AM
Share
New Message
Please login to post a reply