Hotmuck
Back a while ago we had a brief introduction to the existence of the model 56. At the time you had said it wasn't an easy drill to use as it required a little more experience and manpower to handle the bigger cores. Do you know how many holes they are going to drill? Will they then move over to Cougar ? How much money does it take to drill one of these holes? And finally did they have a model 56 over in Timmins, as I read WTM had to abandon one of their deep holes ? At least I think it was WTM in their last release. I was sort of waiting to hear where this drill was going to end up as I was pretty sure Hugh didn't buy it to look at. My gut feeling was that you would only IMHO use it if you had a strong hunch on a deeper target. Bison, Cougar Strikepoint, Wildcat , San etc. There has got to be a source somewhere down deep, lets hope a 7,000 foot drill is the right tool for the job. Maybe they are only after the bigger diameter cores??? Any insight would be appreciated
Rookie
PS
Should have done a fact check on the WTM comment, however I am sorry I have no time.